Cannot find map file. Loaded 20323 symbols from 1 module. Linux version 2.6.22.18 (root@localhost.localdomain) (gcc version 4.2.1) #1 Tue Dec 30 10:13:57 IST 2008 CPU: ARM926EJ-S [56251311] revision 1 (ARMv5TE), cr=00053977 Machine: Feroceon-KW Using UBoot passing parameters structure Memory policy: ECC disabled, Data cache writeback CPU0: D VIVT write-back cache CPU0: I cache: 16384 bytes, associativity 4, 32 byte lines, 128 sets CPU0: D cache: 16384 bytes, associativity 4, 32 byte lines, 128 sets Built 1 zonelists. Total pages: 32512 Kernel command line: console=ttyS0,115200 mtdparts=nand_mtd:0xc0000@0(uboot)ro,0xfd00000@0x300000(root)rw root=/dev/nfs rw nfsroot=10.5.25.250:/srv/dudu/live/ ip=10.5.24.10:10.5.25.250:10.5.24.254:255.255.255.0:DB88FXX81:eth0:none mv_net_config=(00:11:88:0f:62:81,0:1:2:3),mtu=1500 mv_phone_config=dev0:fxs,dev1:fxs PID hash table entries: 512 (order: 9, 2048 bytes) Console: colour dummy device 80x30 Dentry cache hash table entries: 16384 (order: 4, 65536 bytes) Inode-cache hash table entries: 8192 (order: 3, 32768 bytes) Memory: 128MB 0MB 0MB 0MB = 128MB total Memory: 125696KB available (3724K code, 255K data, 104K init) Mount-cache hash table entries: 512 CPU: Testing write buffer coherency: ok NET: Registered protocol family 16 CPU Interface ------------- SDRAM_CS0 ....base 00000000, size 128MB SDRAM_CS1 ....disable SDRAM_CS2 ....disable SDRAM_CS3 ....disable PEX0_MEM ....base e8000000, size 128MB PEX0_IO ....base f2000000, size 1MB INTER_REGS ....base f1000000, size 1MB NFLASH_CS ....base fa000000, size 2MB SPI_CS ....base f4000000, size 16MB BOOT_ROM_CS ....no such DEV_BOOTCS ....no such CRYPT_ENG ....base f0000000, size 2MB Marvell Development Board (LSP Version KW_LSP_4.2.7_patch2)-- SHEEVA PLUG Soc: 88F6281 A0 LE Detected Tclk 200000000 and SysClk 400000000 MV Buttons Device Load Marvell USB EHCI Host controller #0: c0555600 PEX0 interface detected no Link. PCI: bus0: Fast back to back transfers enabled SCSI subsystem initialized usbcore: registered new interface driver usbfs usbcore: registered new interface driver hub usbcore: registered new device driver usb NET: Registered protocol family 2 Time: kw_clocksource clocksource has been installed. IP route cache hash table entries: 1024 (order: 0, 4096 bytes) TCP established hash table entries: 4096 (order: 3, 32768 bytes) TCP bind hash table entries: 4096 (order: 2, 16384 bytes) TCP: Hash tables configured (established 4096 bind 4096) TCP reno registered RTC has been updated!!! RTC registered Use the XOR engines (acceleration) for enhancing the following functions: o RAID 5 Xor calculation o kernel memcpy o kenrel memzero Number of XOR engines to use: 4 cesadev_init(c000c888) mvCesaInit: sessions=640, queue=64, pSram=f0000000 Warning: TS unit is powered off. MV Buttons Driver Load JFFS2 version 2.2. (NAND) © 2001-2006 Red Hat, Inc. io scheduler noop registered io scheduler anticipatory registered (default) Serial: 8250/16550 driver $Revision: 1.90 $ 4 ports, IRQ sharing disabled serial8250.0: ttyS0 at MMIO 0xf1012100 (irq = 34) is a 16550A Loading Marvell Ethernet Driver: o Cached descriptors in DRAM o DRAM SW cache-coherency o Single RX Queue support - ETH_DEF_RXQ=0 o Single TX Queue support - ETH_DEF_TXQ=0 o TCP segmentation offload enabled o Receive checksum offload enabled o Transmit checksum offload enabled o Network Fast Processing (Routing) supported o Driver ERROR statistics enabled o Driver INFO statistics enabled o Proc tool API enabled o Rx descripors: q0=128 o Tx descripors: q0=532 o Loading network interface(s): o eth0, ifindex = 1, GbE port = 0 o eth1, ifindex = 2, GbE port = 1 mvFpRuleDb (c7e0d000): 1024 entries, 4096 bytes Intel(R) PRO/1000 Network Driver - version 7.3.20-k2-NAPI Copyright (c) 1999-2006 Intel Corporation. e100: Intel(R) PRO/100 Network Driver, 3.5.17-k4-NAPI e100: Copyright(c) 1999-2006 Intel Corporation Warning Sata is Powered Off NFTL driver: nftlcore.c $Revision: 1.98 $, nftlmount.c $Revision: 1.41 $ NAND device: Manufacturer ID: 0x20, Chip ID: 0xda (ST Micro NAND 256MiB 3,3V 8-bit) Scanning device for bad blocks Bad eraseblock 1226 at 0x09940000 2 cmdlinepart partitions found on MTD device nand_mtd Using command line partition definition Creating 2 MTD partitions on "nand_mtd": 0x00000000-0x000c0000 : "uboot" 0x00300000-0x10000000 : "root" ehci_marvell ehci_marvell.70059: Marvell Orion EHCI ehci_marvell ehci_marvell.70059: new USB bus registered, assigned bus number 1 ehci_marvell ehci_marvell.70059: irq 19, io base 0xf1050100 ehci_marvell ehci_marvell.70059: USB 2.0 started, EHCI 1.00, driver 10 Dec 2004 usb usb1: configuration #1 chosen from 1 choice hub 1-0:1.0: USB hub found hub 1-0:1.0: 1 port detected USB Universal Host Controller Interface driver v3.0 usbcore: registered new interface driver usblp drivers/usb/class/usblp.c: v0.13: USB Printer Device Class driver Initializing USB Mass Storage driver... usbcore: registered new interface driver usb-storage USB Mass Storage support registered. mice: PS/2 mouse device common for all mice i2c /dev entries driver Linux telephony interface: v1.00 Marvell Telephony Driver: mvBoardVoiceAssembleModeGet: TDM not supported(boardId=0x9) assembly=-1,irq=-1 mp_check_config: Error, invalid voice assembley mode md: linear personality registered for level -1 md: raid0 personality registered for level 0 md: raid1 personality registered for level 1 raid6: int32x1 98 MB/s raid6: int32x2 114 MB/s raid6: int32x4 122 MB/s raid6: int32x8 111 MB/s raid6: using algorithm int32x4 (122 MB/s) md: raid6 personality registered for level 6 md: raid5 personality registered for level 5 md: raid4 personality registered for level 4 raid5: measuring checksumming speed arm4regs : 1084.400 MB/sec 8regs : 755.200 MB/sec 32regs : 900.000 MB/sec raid5: using function: arm4regs (1084.400 MB/sec) device-mapper: ioctl: 4.11.0-ioctl (2006-10-12) initialised: dm-devel@redhat.com dm_crypt using the OCF package. sdhci: Secure Digital Host Controller Interface driver sdhci: Copyright(c) Pierre Ossman usbcore: registered new interface driver usbhid drivers/hid/usbhid/hid-core.c: v2.6:USB HID core driver Advanced Linux Sound Architecture Driver Version 1.0.14 (Thu May 31 09:03:25 2007 UTC). mvCLAudioCodecRegGet: Error while reading register! mvCLAudioCodecInit: Error - Invalid Cirrus Logic chip/rev ID! Error - Cannot initialize audio decoder.at address =0xff<6>ALSA device list: #0: Marvell mv88fx_snd ALSA driver TCP cubic registered NET: Registered protocol family 1 NET: Registered protocol family 17 eth0: link down eth0: started IP-Config: Complete: device=eth0, addr=10.5.24.10, mask=255.255.255.0, gw=10.5.24.254, host=DB88FXX81, domain=, nis-domain=(none), bootserver=10.5.25.250, rootserver=10.5.25.250, rootpath= md: Autodetecting RAID arrays. md: autorun ... md: ... autorun DONE. Looking up port of RPC 100003/2 on 10.5.25.250 eth0: link up, full duplex, speed 1 Gbps Looking up port of RPC 100005/1 on 10.5.25.250 VFS: Mounted root (nfs filesystem). Freeing init memory: 104K